Getting the Most Out of Custom Gallium Iodide UV Lamps
Ever had a project where the surface looked dry, but the moment you touched it, you realized the bottom layer was still a gooey mess? That’s usually where standard mercury lamps fail. They just can’t punch through. That’s why we build Gallium Iodide (GaI) lamps. They shift the light toward those longer UV-A and UV-B wavelengths, which basically means the light travels deeper into the material. The trade-off with power We can tweak the wattage and voltage to fit whatever ballast you’re already running. But here’s the thing: more wattage means more photons, which is great for a fast cure, but it also means more heat. If your conveyor belt isn’t cooled properly, you’re risking warped substrates. Double-check your fans before you crank up the power. It’s a headache you don’t want. Built to actually fit There’s nothing worse than ordering a “replacement” part that doesn’t actually fit the machine. We use high-purity fused quartz so you don’t lose any light, and we build the length and diameter to match your specific footprint. We handle the end-caps and wiring, too. If you’re swapping out a big-name brand, we match the electrical impedance exactly. Why? Because if it’s off, you’ll either fry your ballast or burn out your electrodes way too early. We make it a simple drop-in. What to expect on the floor These are the go-to lamps for thick-film resins and heavy-duty adhesives. You get a much better depth-of-cure, but there is one catch. They take a bit longer to warm up than the basic lamps. Just give them a few extra minutes to hit full strength. Our promise We’re confident in these. If our custom GaI lamp doesn’t hit the same curing speed or hardness as the expensive brand-name versions, we’ll give you your money back. You get the same rock-solid results. You just don’t have to pay the “brand name” tax.